Saturday, 24 May 2014

Billy bookcase height extension units

Apparently there have been some 41 million Billy bookcases sold by Ikea since their launch in 1979, and I have at least 17 of them and need to order some more soon. As part of our recent building project we have had a garden office built and set out to equip it with Billys. Sadly, it is not quite tall enough for the full height 202cm bookcases so we have had to buy the shorter 106cm units.

However, Ikea sell extension units, but they are only intended to go on the full height units. This is frustrating as I could fit a four shelf unit into the new office quite easily. Not being an avid DIYer, I considered this and worked out that even I could get the extension units connected to the half height units.

All the needs to happen is for two holes to be drilled in the top of the bookcases. Measuring from the back of the side panels, a hole with a 5mm diameter and 10mm depth (wrap some insulating tape around the drill bit 10mm from the end and stop drilling when it meets the shelf) needs to be drilled with a centre at 241.5mm and at 8.5mm from the edges. Once this has been drilled on either side, Ikea's instructions can be followed again.

One other little refinement I made was flipping over the top shelf of the extension so that the four locking screws are inside the bookcase, rather than being on the top (as a four shelf unit is still low enough to see the top easily).

The extension units have these holes drilled in them so a further extension unit could easily be added to the top making a five shelf unit.

These measurements worked for me today with the units I bought recently. If Ikea modify their design at any point, I cannot guarantee they will work again: if you have found this post while looking to see if the extension units can be added to the 106cm bookcases, do check the measurements carefully on your units.